Для заявок - dmc@itmash.ru

   Other than keeping the unit clean and     MILITARY       DMC          Description                NSN
properly stored when not in service,              P/N        P/N
no operator maintenance is required.                                       TOOL FRAME       5120-01-335-8571
DMC offers complete factory service          M22520/1-01      AF8              TURRET       5120-01-335-8834
by knowledgeable technicians within a        M22520/1-02     TH1A              TURRET       5120-01-335-8835
reasonable turnaround time. Complete         M22520/1-03      TH4              TURRET       5120-01-335-8836
instructions concerning the use, care        M22520/1-04    TH163                           5120-01-335-8583
and warranty are supplied with each          M22520/1-05    UH2-5          ADJUSTABLE
tool. Additional copies are available on                                    POSITIONER      5120-01-335-8584
request.                                     M22520/1-06     TP45           POSITIONER      5120-01-335-8585
                                             M22520/1-07     TP85           POSITIONER      5120-00-016-7654
   Pneumatic versions of this tool are       M22520/1-08   TH199S                           5120-01-335-8586
found on page 12.                            M22520/1-09    TP360              TURRET       5120-01-335-8587
                                             M22520/1-10    TP365           POSITIONER      5120-01-335-8588
   The battery powered versions of this      M22520/1-11    TP465           POSITIONER      5120-01-335-8838
tool are found on page 10.                   M22520/1-12    TH270           POSITIONER      5120-01-036-9221
                                             M22520/1-13    TH285                           5120-01-036-9222
   The DMC1186 tool kit contains the AF8     M22520/1-14    TH286              TURRET       5120-01-335-8589
tool frame, tool gage, and all mil-spec      M22520/1-15    TP485              TURRET       5120-01-335-8590
positioners and turret heads. Also included  M22520/1-16    TP513              TURRET       5120-01-335-8591
in the DMC1186 are tool instruction          M22520/1-17    TP651           POSITIONER      5220-01-016-6002
sheets and a tool selection chart.           M22520/3-1      G125           POSITIONER
                                                          DMC1186           POSITIONER               Step 2
      Periodic gaging is recommended
   to insure accurate calibration. This                                          GAGE
   can be done easily by setting the                                     M22520/1 Tool Kit
   tool selector knob to position #4,
   and checking indenter closure with                     Step 1
   the M22520/3-1 “GO/NO-GO” gage
   (DMC part no. G125).

                                             Insert contact              Insert pre-stripped Wire

                                                          Step 3                            Step 4

                                             close / open handle         remove terminated wire assembly
                                                                                                                           PAGE 7
                                                  www.itmash.ru
                                                 dmc@itmash.ru
                                               +7 (495) 668-13-58